Canon Colorado M Series Operation Manual page 83

Print mode set‐ Description
ting
[Advance correc- Controls the average step size for the selected media and print mode. Only
tion (Caldera) / change this setting when media calibration, [Automatic advance correction],
Step correction and decreasing the vacuum settings do not help enough in improving the
(ONYX)] print quality.
Decrease for smaller steps, in case of constant light lines (at the swath
boundary). Increase for larger steps, in case of constant dark lines. When
both light and dark lines are present, you cannot correct it via this setting.
[Print direction] There are two options for this setting:
• Bidirectional is the default option.
• A monodirectional option is available for all print modes at half produc-
[High Density] Available for matte print modes on textured media. Ink coverage +25%
[Optimized color The [Optimized color profiling] level is set as part of the color profiling se-
profiling] quence. When the level is set to 1, no color corrections are made. In case of
wrinkles, increase the [Optimized color profiling] in order to reduce the ink
limit in an optimized way. This will reduce the risk of wrinkles.
[Adhesion] There are two options for this setting:
• [Normal] is the default option.
• [Enhanced] is available for white ink print modes. Use this setting when
[Flood Fill
Only for FLXfinish
(Gloss)]
When this setting is checked and there is no gloss layer, the print is fully
Gloss.
When this setting is not checked and there is no gloss layer, the print is fully
Matte.
[Flood Fill Only for white ink print modes.
(White)] When this setting is checked, the printer generates a white flood fill. This
substitutes white spot data.
[Define layers] Only for white ink print modes.
Define the layer structure for multilayer prints.
NOTE
• The [Automatic advance correction] setting will still work when
you use [Advance correction/Step correction].
• The change of this setting is only applied to a job when the
queue is empty. Send jobs one by one to make sure that the
changes are applied
tivity. Monodirectional means that the engine prints and cures only in one
direction.
adhesion of ink to media is low. This setting reduces print speed.
+
.
Change the media settings
Chapter 4 - Handle the media 83