Test Prismasync Remote Control - Canon Colorado M Series Operation Manual

Test PRISMAsync Remote Control

Test PRISMAsync Remote Control
Introduction
When you have configured PRISMAsync Remote Control, you can test the connection between
PRISMAsync Remote Control and the cloud services.
Before you begin
Make sure you have configured PRISMAsync Remote Control. For more information, see
Configure PRISMAsync Remote Control on page
Procedure
1. Open the settings editor.
2. Click on [Configuration] →[Connectivity].
3. First, test the connection between the printer and the cloud services:
4. Next to [Test Remote Control], click on [Send test notification]. A window opens.
5. Click on [Send test notification].
The result must be successful. In case of error:
• Make sure that in the settings editor,[Configuration] →[Connectivity]→[Remote Control] is
enabled.
• Make sure that on the operator panel, [System]→[Remote services]→[Remote connection] is
enabled.
• Make sure that on the operator panel,[System]→[Remote services]→[Proxy settings] the proxy
settings are correct.
• Make sure that on the operator panel, [System]→[Remote services]→[Remote connection]→
[Test remote connection] the status is connected.
6. Second, test the connection between the cloud services and your mobile device:
7. Click on [Register printer for cloud services]. A new page opens.
8. Log in with your Microsoft or Google administrator account. A new page opens.
9. Click on [Send test notification].
284 Chapter 8 - Configure the network and security settings
282.