Canon Colorado M Series Operation Manual page 68

FLXfinish⁺ in the RIP
3. To check that the gloss part will be printed: hover the mouse over an area in the image that
should be printed in gloss. Check at the bottom of the Job Editor whether there is a CMYK
value and Spot2 value. If that is the case, the PDF file is made up correctly and will be printed
in matte and gloss when using the FLXfinish
PDF file settings for Caldera
In order to verify if the PDF file is made up correctly, some things need to be checked.
1. Open the correct printer version.
2. Set the correct media profile and print mode.
3. Drag the desired FLXfinish
4. Go to the Spot button.
68 Chapter 4 - Handle the media
+
print mode.
+
PDF file to the image selection area.