Canon Colorado M Series Operation Manual page 135

4. Optional (licensed): set [ Wind the printed side] to [ Outside] or [Inside].
The default value is [ Outside]. When the setting is not available, the output will be winded with
the printed side to the outside.
5. Start a print job.
The printer spools the media until it reaches the tape position. The clamp closes and the operator
panel gives a message indicating you can tape the media.
6. Make sure the media guides are out of the way as they can damage the media.
7. Take the leading edge of the media and align it on the core.
8. Tape first the center and then the sides of the media to the core, as shown on the operator panel.
For outside winding feed the media along the front of the core, for inside winding feed the media
along the back of the core.
for outside winding:
Print and wind with a locked tension bar
Chapter 4 - Handle the media 135