Water Supply - Norton Clipper C1418P Owner's Manual

Move the Engine Throttle Slightly to the Left
C1418P Kohler Powered
Turn the Console ON/OFF Switch to the ON
Position.
C1418P Kohler Powered
As the engine warms up, gradually move the choke
lever to the OPEN position (fully to the right)
To stop the engine, move the Throttle Control Lever fully to the Slow Position
(fully to the rear, turn the Console ON/OFF Switch to the OFF position, move
the Fuel Control Lever fully to the LEFT (this will turn off the fuel), and Kohler
Engine On/Off switch to the OFF Position.
Never transport the machine with the Fuel Valve in the ON
position. Never Store the machine with the Fuel Valve in
the ON position. Never Transport a machine with the blade
installed.
C. Water Supply
Pressurized source: Turn the water control to full "ON" when using wet
cutting blades. The required flow rate is 4-6 gallons per minute.
Place the engine ON/OFF switch to the ON position
and NOTE: The Engine ON/OFF Switch is located
on the front of the Engine.
C1418P Kohler Powered
Pull the starter grip lightly until you feel resistance,
then pull briskly. CAUTION: Do not allow the starter
grip to snap back against the engine. Return it gently
to prevent damage to the starter.
C1418P Kohler Powered
Position the throttle control lever for the maximum
engine speed before cutting (fully Forward).
13