Table of Contents
Advertisement
Installer Manual Fleck 5810 - XTR - Programming
6.3.11. Non-factory setting
After all parameters in master setting have been set, press
display the non-factory settings screen.
Press
to save all programmed master settings parameters to non-factory settings. At any point,
the controller can be reset to these saved custom settings (see 6.4.1. Error log, page 90). Press
return to the master settings screen without saving.
Note
By performing a custom reset, any setting that is subsequently programmed without saving
to non-factory settings will be reset to the previously saved non-factory settings in the
controller.
6.4.
Diagnostics
The controller records and displays a variety of diagnostic data to assist with troubleshooting
performance issues and fine-tuning system efficiency.
From the master settings or home screens, press the diagnostics button
screen.
Press the screen navigation arrows at the upper-right and left of the screen to view each diagnostic
parameter.
Press the home button
88 / 124
Non-factory settings
current settings will
be saved as
the non-factory settings?
Diagnostics
flow rate
peak flow
totalizer
to return to the home screen.
on the master settings screen to
to access the diagnostics
5.7
Lpm
9.2
Lpm
153
L
Ref. MKT-IM-018 / C - 08.06.2018
to
Advertisement
Table of Contents
