Commands; Setting The Time Of The Day (Td) - Pentair FLECK 5810 SXT Installer Manual

Regeneration cycles:
2. Data display
3. PM indicator
4. Flow indicator
5. x1000 indicator
6. Programming icon
7. Service icon
8. Error /
Information icon
6.2.

Commands

A Press to pass to the next step.
B Use and
6.3.

Setting the time of the day (TD)

Set the time in the system.
A Press and hold
icon and the parameter display reads TD.
B Set the time with
C Press to validate the selection and return to the service mode, or wait
for 10 seconds.
Ref. MKT-IM-016 / C - 08.06.2018
→ B1: First backwash (for dF2b regeneration mode);
→ B2: Second backwash (for dF2b regeneration mode);
→ BD: Brine draw;
→ BF: Brine fill;
→ BW: Backwash;
→ LC: Last cycle (for "other" regeneration mode);
→ RF: Refill (for "other" regeneration mode);
→ RR: Rapid rinse;
→ SP: Service position (for "other" regeneration mode);
→ SR: Slow rinse (for "other" regeneration mode);
→ SV: Service position for brine preparation (for "UFFF"
regeneration mode).
→ Appears if controller set in US unit.
→ Flashes when outlet flow is detected.
→ Appears when the displayed number is bigger than 9999.
→ Appears in programming modes.
→ Appears in service mode;
→ Flashes if a regeneration cycle has been queued.
→ Appears in case of error, see page 96, or in diagnostic mode, see
page 71.
to adjust the values.
or until the programming icon replaces the service
or .
Installer Manual Fleck 5810 - SXT - Programming
53 / 106