Replacing The Optical Sensor - Pentair FLECK 5810 XTR Installer Manual

9.2.8. Optical sensor replacement
No.
A Remove the controller, see 9.2.2. Controller replacement, page 98.
B Release the optical sensor support (1) by pushing it back and up as shown.
C Release the optical sensor (3) from its support (1) by pressing the clips (2).
D Disconnect the wire from the motor to the optical sensor (4).
E Change the optical sensor (3).
F Reverse above procedure steps to rebuild.
Ref. MKT-IM-018 / C - 08.06.2018
Installer Manual Fleck 5810 - XTR - Maintenance
Operation
107 / 124