Table of Contents
Advertisement
Installer Manual Fleck 5810 - XTR - Programming
Screen name
Parameters
Volume
Valve
override
Regeneration
Regeneration
flow
Relay output
Aux.1/Aux.2
Meter
Meter type
66 / 124
Values
1 to 999 999 999
Only displayed when regeneration type is filter
gallons/liters
immediate or filter delayed.
Cycle steps on the home screen and during
regeneration will change to reflect the cycle
steps and order in the selected regeneration
flow.
Downflow
Additional regeneration screen parameters
Downflow 2x BW
are dependent upon selected regeneration
Upflow
flow. Not all parameters will be displayed,
Custom Downflow
depending of the selected regeneration flow.
Custom Upflow
Custom upflow, downflow and filter allows for
Variable Refill
up to 20 programmable cycle steps.
Filter
Variable refill calculates refill time based on
Custom Filter
salt dosage, media volume, and BLFC Size,
and it is not possible to change it.
Time per cycle step can be programmed for
all other regenerant flow options.
For cycle based relays, select the cycle steps
on which the relays will turn on. For time
based relays, two start/end times can be
selected for each relay. Relay times are based
Alarm Based
on total regeneration cycle time.
Cycle Based
Volume based relays can be programmed
Time Based
from one gallons/liters to the full system
Volume Based
volume capacity. Duration can be set from one
Off
second to two hours. Volume based option is
not available when regeneration type is set to
time clock. Alarm based relays will turn on
when an alarm condition is met, and will turn
off when the alarm is cleared.
Only available when meter regeneration type
0.75" Paddle
is selected.
1.00" Paddle
Select the type of meter installed with the
1.25" Turbine
system. A generic option is available if the
1.50" Paddle
installed meter does not match any other
1.50" Turbine
selection. Selecting the generic meter type
2.00" Paddle
requires setting the number of pulses per
3.00" Paddle
gallon or liter to ensure proper metering.
Generic
The standard setting for 5810-XTR is 1.25"
Turbine.
Notes
Ref. MKT-IM-018 / C - 08.06.2018
Advertisement
Table of Contents
