Commands; Setting The Time Of The Day (Td); Basic Programming; Day Of Override (Do) - Pentair FLECK 5800 SXT Installer Manual

2. Data display
3. PM indicator
4. Flow indicator
5. x1000 indicator
6. Programming icon
7. Service icon
8. Error /
Information icon
6.2.

Commands

A Press to pass to the next step.
B Use and
6.3.

Setting the time of the day (TD)

Set the time in the system.
A Press and hold
icon and the parameter display reads TD.
B Set the time with
C Press to validate the selection and return to the service mode, or wait
for 10 seconds.
6.4.

Basic programming

Note
Menus are displayed in a defined and incremental order.

6.4.1. Day of Override (DO)

Determine the maximum number of days of operation without regeneration.
A Press and
sequence.
B Select the number of days of Override with
C Press to validate the selection and advance to the next parameter.
Ref. MKT-IM-004 / A - 18.04.2017
→ Appears if controller set in US unit.
→ Flashes when outlet flow is detected.
→ Appears when the displayed number is bigger than 9999.
→ Appears in programming modes.
→ Appears in service mode;
→ Flashes if a regeneration cycle has been queued.
→ Appears in case of error, see page 75, or in diagnostic mode, see
page 61.
to adjust the values.
or until the programming icon replaces the service
or .
simultaneously for 5 seconds to enter the menus
Installer Manual Fleck 5800 - SXT - Programming
and .
47 / 92