Displaying The Performance; Setup Menu; General Settings; Setting The Language - Pentair LINEGUARD UF-100 Manual

the date of the last time the modules were replaced is displayed by pressing \/.
this date can be changed by pressing set. this should be done after every module replacement.
Exit the service info menu by pressing exit.

4.2.3 Displaying the performance

In the info menu press /\ or \/ until the next screen appears:
the performance of the system is displayed by pressing show.
the following data is now displayed:
F = current flow in l/min
J = current flux in l/(m2.h.b)
pi = pressure at the feed water side in bar
po = pressure at the filtered water side in bar

4.3 setup menu

In this menu all the settings of the LineGuard can be defined.
In the operating mode menu press menu and then press /\ or \/ until the next screen appears:
10
EN

4.3.1 General settings

In this menu, language, clock, date and module specifications can be set. In the setup menu, press /\ or \/
until the screen below appears:

4.3.1.1 setting the language

In the general settings menu press /\ or \/ until the screen below appears:
the language can be changed by pressing set.
select the preferred language by pressing the - and + buttons and press ok. optional languages are English,
German and spanish.

4.3.1.2 setting the clock

In the general settings menu press /\ or \/ until the screen below appears:
the time on the clock can be set by pressing set. First set the hours by pressing the - and + buttons and
press ok. then set the minutes by pressing the - and + buttons and close by pressing ok.
11
EN