Table of Contents
Advertisement
10/2020
1006351-04B
12.16.6
Cleaning or replacing lamps in the base
–
Remove the acrylic panel: see page 57.
–
Remove the lamp coverings at the head and foot ends.
Replace the lamps: see page 61.
Replace the starter: see page 63.
–
Remove the partition and carefully set aside (only for devices with an air
conditioning unit).
The assembly is the same process in reverse order.
When assembling the device please note:
–
When positioning the lamp covering push the pins into the opening.
Crushing hazard due to improper maintenance!
If the acrylic panel is mounted backwards, there will be a
gap between front panel and acrylic panel.
–
Always replace the acrylic panel as shown: The imprint
on the panel must be next to the foot end at the rear
side of the device.
–
Remove fingerprints and other soiling carefully.
How to use this device
WARNING!
Operating Instructions – 65/88
Advertisement
Table of Contents
