Table of Contents
Advertisement
10/2020
1006351-04B
12.12.3
How to stop
The tanning session ends automatically after the preset time has run down.
The internal body cooling fan continues to run for approx. three (3) minutes to
sufficiently cool the device.
–
To interrupt a tanning session, press and hold button START/STOP any-
time during a session.
–
Press START/STOP again to restart the lamps.
12.13
What to do after the treatment
12.13.1
Cleaning and disinfection
Infections can be transferred through skin contact.
All items/equipment components, with which the user can
come into contact during tanning, must be cleaned and
disinfected after every tanning session:
–
Protective goggles
–
Acrylic panels
–
Handles and control panel
–
AUX cable
–
Adjustable air nozzles
–
Use only EPA registered quaternary ammonium germi-
cidal based detergent solution (follow product label for
use-dilution), such as Lucasol One Step, to clean and
disinfect the tanning system and its components.
NOTE:
For thorough cleaning and disinfection, the product must be
allowed to remain in contact with the surface being cleaned
and disinfected for a specified amount of time.
This specified amount of time depends on the cleaner/
disinfectant which is used. Follow the directions for use of the
cleaner/disinfectant.
After this specified application time remove remaining clean-
er/disinfectant from the surfaces of the device. Use a single-
pass paper towel.
Once the remaining cleaner/disinfectant has been removed,
perform a visual inspection for signs of any remaining clean-
ing solution, or areas still soiled. If either are remaining, re-
peat the cleaning process until a visual inspection can be
successfully completed without the need for additional clean-
ing.
If any of the components listed above cannot be successfully
cleaned and disinfected, they must be replaced.
How to use this device
WARNING!
Operating Instructions – 47/88
Advertisement
Table of Contents
