Auto Mode - Newland EM1300 Integration Manual

General Programming General Programming
Reading Mode

Auto Mode

First program the engine, then trigger it, the engine will start to scan. After a scan, the
engine will not stop but start a new one automatically until another trigger. By default,
the engine will not repeat reading a same barcode.
In auto mode, the engine could set Reading a barcode time length, and set if it could read same barcode.
Disable Reading Same Barcode
【Pro CMD：99900155】
Enable Reading Same Barcode
【Pro CMD：99900156】
Reading Same Barcode
»
When enabled，after a successful read, the engine will not stop but start a new one automatically until
another trigger.
When disabled，after a successful read, if the next barcode is the same one, the engine will keep waiting.
If the next barcode is different, the engine will not stop but start a new one automatically until another trigger.
Restart Timer After a Valid Reading
»
When enabled, after a successful read, the engine will revert the reading time to zero and restart timer.
nlscan.com
Auto Mode
【Pro CMD：99900111】
Reading a barcode time length
【Pro CMD：99900150】
Code Programming ON
Code Programming OFF
Restart Timer After a Valid Reading
【Pro CMD：99900157】
Tools
Page 28