Auto Mode - Newland HR11+ Aringa User Manual

Auto Mode

Auto Mode: Pressing the trigger activates a decode session. The decode session continues until the
barcode is decoded or the decode session timeout expires (default: 15 seconds; user programmable).
The scanner automatically starts one session after another until you press the trigger a second time.
Decode Session Timeout
Decode Session Timeout: This parameter sets the maximum time decode session continues during a
scan attempt. It is programmable in 1,000ms increments from 1,000ms to 15,000ms. When it is set to 0,
the timeout is infinite. The default timeout is 15,000ms.
To program this parameter, scan the Decode Session Timeout barcode, the numeric barcodes and the
Save barcode. To find the numeric barcodes, see the "Digit Barcodes" section in Appendix.
Example: Set the decode session timeout to 2,000ms
1. Scan the Enter Setup barcode.
2. Scan the Decode Session Timeout barcode.
3. Scan the numeric barcodes "2", "0", "0" and "0" from the "Digit Barcodes" section in Appendix.
4. Scan the Save barcode from the "Save/Cancel Barcodes" section in Appendix.
5. Scan the Exit Setup barcode.
23
Auto Mode
Decode Session Timeout
** Enter Setup
Exit Setup