Code Programming - Newland EM1300 Integration Manual

General Programming General Programming

Code Programming

Read the "Code Programming ON" barcode to activate "Code Program-
ming" function. More than one Code Programming barcodes can be read to
configure the Engine.
If an option or feature needs additional parameters, such as digits, they can be
found at the end of this chapter.
The value of code programming can be sent to the Host. For factory default,
"No Send Pro Code Value", the value of programming codes will not be
sent to the Host; by reading "Send Pro Code Value", the reader will send the
value of Programming Code to the Host.
The factory default setting is "Code Programming ON". Because it has low probability that a data
barcode is the same as a programming barcode, it doesn't need to close the function of Code Program-
ming. Keeping it on won't affect the daily using.
Some working parameters could be programmed. The data type of parameters is Dec or Hex and the numbers
are also input through programming barcodes. The Appendix of the Integration Guide includes all needed
data barcodes.
Programming barcodes are used to program the engine. For factory default, the reader will not send code
value to the Host. But if needed, the engine could be programmed to "Send Pro Code Value". And whether
the value is sent or not won't affect the programming function. But "Send Pro Code Value" is a temporary
setting. It will restore to "No Send Pro Code Value" when the engine is restarted or closed.
Code Programming ON
【Pro CMD：99900031】
No Send Pro Code Value
【Pro CMD：99900033】
nlscan.com
Tools
Code Programming ON
Code Programming OFF
Code Programming OFF
【Pro CMD：99900032】
Send Pro Code Value
【Pro CMD：99900034】
Page 22