Mitsubishi Electric FR-E720-0.1 K Instruction Manual page 189

(1) Operation mode basics
The operation mode specifies the source of the start command and the frequency command for the inverter.
Basically, there are following operation modes.
External operation mode: For inputting start command and frequency command with an external potentiometer and
switches which are connected to the control circuit terminal.
PU operation mode: For inputting start command and frequency command with the operation panel or parameter unit
(FR-PU04 / FR-PU07).
Network operation mode (NET operation mode): For inputting start command and frequency command with RS-485
communication through PU connector or communication option.
The operation mode can be selected from the operation panel or with the communication instruction code.
GOT
Programmable controller
REMARKS
Either "3" or "4" may be set to select the PU/External combined mode. Refer to page 186 for details.
The stop function (PU stop selection) activated by pressing
PU07) is valid even in other than the PU operation mode in the initial setting.
(Refer to Pr. 75 Reset selection/disconnected PU detection/PU stop selection (page 179))
Selection of operation mode and operation location
PU operation mode
FR-PU07
Network
operation mode
Personal computer
PU operation mode
Inverter
USB
connector
PU operation mode
Operation panel
PU connector
Communication
option card
Control terminal
External
operation mode
of the operation panel and parameter unit (FR-PU04/FR-
Personal computer
5 6
4
3 7
2
8
1
9
10
Potentiometer
Switch
187
4