Table of Contents
Advertisement
Copy Output Order Mode
The documents always come out face up. When you are copying multiple pages, the stacking order of the
output pages is determined by the setting you selected in the Output Order Mode: Correct Order Stacking -
"2:Ascending" (1,2,3....) or Reverse Order Stacking - "1:Descending" (3,2,1....).
When the Output Order Mode is set to "2:Ascending", the documents are stored in memory, and then
printed in the Correct Order Stacking. To print in "Ascending" order requires the Output Order Mode be set
to "2:Ascending" in Copier Parameter No. 17 (OUTPUT ORDER DEF.), and enough memory.
When the Output Order Mode is set to "1:Descending", the documents always come out in descending
order one page at a time.
12
Original Document Order
1
2
3
NOTE
1. When Copy Parameter NO.17 (OUTPUT ORDER DEF.) is set to "2:Ascending", it takes more time to finish copying be-
cause all documents will be stored in memory. When you are copying multiple pages, the machine will start printing after
all the documents are stored in memory regardless of the setting.
2. If the memory overflows while documents are being scanned for copying, separate the documents into smaller stacks
and copy them. To make one set of copies, separate the documents into smaller stacks or set the Output Order Mode to
"1:Descending". (See page 163)
Copy Output Order
Correct Order Stacking
(Collation Mode)
1
2
3
Copier Parameter No.17:
"2:ASCENDING"
(Initial Setting)
Basic Copy
Reverse Order Stacking
(Non-Collation Mode)
3
2
1
Copier Parameter No.17:
"1:DESCENDING"
71
Advertisement
Table of Contents
