Entering The Simulation Mode; List Of Simulations - Toshiba GD-1300 Service Manual

[4] SIMULATION

1. Entering the simulation mode

To enter the serviceman simulation mode, press the keys as follows:
[#] key → [∗] key → [Clear] key → [∗] key
To cancel the simulation mode, press the [Clear All] key.
2. Key rule
[Numeric] key: Entry of MAIN CODE/SUB CODE
Selection of an item
Setup of an adjustment value in case of simulations for adjustment
[ ] [ ] key: Selection of MAIN CODE/SUB CODE
Selection of an item
[ENTER]/[OK]/[START] key: Settlement
<In case of simulations for print>
[ENTER]/[OK] key: Settlement (Without print)
[START] key:
[Clear] key: (Interrupting operation check) Returns to the upper hierarchy.
In case of simulation of operation check, terminates the operations.
[Clear All] key: Exits from the simulation mode.
For a simulation of adjustment, the display returns to the initial display (00-00).

3. List of simulations

Main Sub
code code
22 11 FAX-related counter display
24 10 FAX counter clear
46 12 Density adjustment in the FAX mode (Collective
adjustment)
13 FAX mode density adjustment (Normal text)
14 FAX mode density adjustment (Fine text)
15 FAX mode density adjustment (Super fine)
39 FAX mode sharpness adjustment
66 01 FAX soft SW setting
02 FAX soft SW initializing (excluding the adjustment
values)
03 FAX PWB memory check
04 Signal send mode (Max. value)
05 Signal send mode (Soft SW set value)
07 Image memory content print
Settlement/Print
Contents
GD-1300 SIMULATION 4 - 1
Main Sub
code code
66 10 Image memory content clear
11 300bps signal send (Max. value)
12 300bps signal send (Soft SW set value)
13 Dial test
17 DTMF signal send (Max. value)
18 DTMF signal send (Soft SW set value)
21 FAX information print
24 FAST SRAM clear
30 TEL/LIU status change check
33 Signal detection check
34 Communication time measurement
37 Speaker sound volume setting
38 Time setting/check
Contents