UNI-T UDP3000S Series Programming Manual page 46

Programming Manual
:SYSTem:COMMunicate:LAN:APPLy
Format：:SYSTem:COMMunicate:LAN:APPLy
Function：Apply the network parameters that have been set.
Description：When use the command":SYSTem:COMMunicate:LAN:xxxx"(xxxx represents other network setting
command in LAN) to set the network parameter, the setup parameter will not take effect immediately
and will not save to nonvolatile memory of the device. It must execute the command
":SYSTem:COMMunicate:LAN:APPLy"to make the parameter validly and save permanently. You can
execute multiple commands to modify multiple parameters and then execute a single
":SYSTem:COMMunicate:LAN:APPLy" command together.
For Example：:SYSTem:COMMunicate:LAN:DHCP:STATe ON
:SYSTem:COMMunicate:LAN:APPLy
set.
:SYSTem:COMMunicate:LAN:DHCP[:STATe]
Format：:SYSTem:COMMunicate:LAN:DHCP[:STATe] {0|1|OFF|ON}
Function：Turn on/off DHCPFunction of the network.
Description：When use this command to set the network parameter, the setup parameter will not take effect
immediately and will not save to nonvolatile memory of the device. It must execute the command
":SYSTem:COMMunicate:LAN:APPLy"to make the parameter validly and save permanently. You can
execute multiple commands to modify multiple parameters and then execute a single
":SYSTem:COMMunicate:LAN:APPLy" command together.
For Example：:SYSTem:COMMunicate:LAN:DHCP:STATe ON
:SYSTem:COMMunicate:LAN:APPLy
:SYSTem:COMMunicate:LAN:DHCP[:STATe]？
Format：:SYSTem:COMMunicate:LAN:DHCP[:STATe]？
Function：Query the switch status of DHCPFunction of the network.
Description：After the network parameter is set and before executing the
command":SYSTem:COMMunicate:LAN:APPLy", the result queried by this command is the temporary
parameter and it reflects the parameter data used when executing the command
":SYSTem:COMMunicate:LAN:APPLy". Otherwise, the result queried by this command is the currently
operating parameter of the device.
It returns"{ON|OFF}".
For Example：:SYSTem:COMMunicate:LAN:DHCP:STATe?
Return：ON
:SYSTem:COMMunicate:LAN:IPADdress
Format：:SYSTem:COMMunicate:LAN:IPADdress "x.x.x.x"
Function：Set IP address of the device.
Instruments.uni-trend.com
Turn on DHCPFunction.
Apply the network parameters that have been
Turn on DHCPFunction.
Apply the network parameters that have been set.
UDP3000S Series
46 / 49