Table of Contents
Advertisement
The function of each parameter
THRESHOLD
This adjusts the level at which the effect will be made
apparent.
RATIO
This parameter is for both "STEREO MULTI," "10 GRAPHIC
EQ" and "VOCAL MULTI." Selects the extent to which the
signal will be compressed (compression ratio) while the
Limiter is working.
SUSTAIN
Adjusts the range (time) over which low-level signals are
boosted. Larger values will result in longer sustain.
ATTACK
Adjusts the strength of the attack. Larger values will result in
a sharper attack, creating a more clearly defined sound.
RELEASE
This adjusts the time from when the signal level drops below
the threshold until when limiting is removed.
ENH FREQ (enhance frequency)
This is the parameters for "BASS MULTI." This sets the
frequency band where you wish to apply the Enhancer effect.
Increasing the value will target a higher frequency band.
ENH LEVEL (enhance level)
This is the parameters for "BASS MULTI." This adjusts the
intensity of the Enhance effect. Increasing the value will
emphasize the Enhance effect.
TONE
Adjusts the tone.
LEVEL
Adjusts the volume.
<When "LIMIT (limiter)" is selected>
EFFECT
This parameter turns the Limiter effect on/off.
THRESHOLD
Adjusts this as appropriate for the inputs signal. When the
input signal level exceeds this threshold level, limiting will
be applied.
94
ATTACK (attack time)
This is the parameter for "MIC SIMULATOR." Adjust the
time from when the input level exceeds the threshold level to
when the effect begins to apply.
RELEASE
This adjusts the time from when the signal level drops below
the threshold until when limiting is removed.
DETECT HPF (detect frequency)
This is the parameter for "MIC SIMULATOR." Adjust the
cutoff frequency of the level detection section. With a setting
of Thru, this will operate as a conventional limiter.
TONE
Adjusts the tone.
LEVEL
Adjusts the volume.
DE-ESSER
Useful for reducing 'sibilant' or 'S' sounds produced by a
vocalist.
EFFECT
This parameter turns the de-esser effect on/off.
SENS (sensitivity)
Adjusts the sensitivity relative to the input volume, which
controls how the effect is applied.
FREQUENCY
Set the frequency at which the de-esser effect will be applied.
The effect will be made apparent in the frequencies above the
frequency set here.
Advertisement
Table of Contents
