Table of Contents
Advertisement
fig.1-23
1. Press [UTILITY].
2. Rotate [VALUE] to select "SYSTEM."
fig.1-24
3. Press [ENTER].
4. Use PARAMETER [
screen, and select "NUMBER U/D MIN."
fig.1-25
5. Rotate [VALUE] to select "PA 1."
6. Use PARAMETER [
MAX."
7. Rotate [VALUE] to select "UB100."
8. Use PARAMETER [
screen, and select "CONTROL 1."
9. Rotate [VALUE] to select "NUMBER UP (DOWN)."
fig.1-26
10. Use PARAMETER [
11. Rotate [VALUE] to select "NUMBER DOWN (UP)."
* If you are using only one foot switch, this setting will have no
effect.
12. Press [UTILITY] to return to Play mode.
* If you press [EXIT] in step 12, you will return to step 2. If you
press [EXIT] once again, you will return to Play mode.
1,12
2,3,5,7,9,11
4,6,8,10
][
] to access the following
][
] to select "NUMBER U/D
][
] to access the following
][
] to select "CONTROL 2."
Section 1. Producing Sound
* In Play mode when the display indicates "CATEGORY On,"
you can step through patches of the same category. If you press
[EXIT] in Play mode, the display will indicate "CATEGORY
OFF," and you will be able to step through the range of patches
that you specified by the "NUMBER U/D MIN" and
"NUMBER U/D MAX" settings.
When using only one foot switch:
Each time you press the foot switch, the patch number will
increase.
* If in step 8 you selected "NUMBER DOWN," the patch
number will decrease.
* If you have connected only one pedal, the "CONTROL 2"
setting will have no effect.
* You can change the range of patch numbers that are selected
when you press the foot pedal. For details refer to "SYSTEM
SETTING" (p.43).
When using two foot switches:
Each time you press CONTROL 1, the patch number will
increase. Each time you press CONTROL 2, the patch
number will decrease.
* If in steps 8 and 10 you select "NUMBER UP" and
"NUMBER DOWN" in reverse, the result of pressing
CONTROL 1 and CONTROL 2 will also be reversed.
• Selecting Effect Sounds with an FC-200
MIDI Foot Controller
If an FC-200 MIDI Foot Controller (optional) is
connected, you can switch Patch numbers by pedal
operations on the controller. For details refer to "VF-1
operation using the FC-200" (P.127).
• Selecting Effect Sounds by MIDI Messages
VF-1 Patches can be selected by Program Change
messages from an external MIDI device.
For details refer to "Using MIDI to Operate the VF-1"
(p.122).
21
Advertisement
Table of Contents
