Table of Contents
Advertisement
The function of each parameter
FLT DEPTH (filter depth)
This adjusts the depth of the filter. When the value is higher,
the filter will change more drastically. The polarity of the
filter will be opposite with "+" and "-."
ATTACK (attack decay)
This adjusts the time needed for a synthesizer sound to reach
its maximum. When it is set to a lower value, the sound will
rise quickly. When it is set higher, the sound will rise slowly.
When it is set to "Decay," the sound will rise quickly and
turn to a Release status regardless of the input of the guitar
sound.
* When "BRASS" or "BOW" is selected for the wave, the attack
time will not be quicker from a certain level even if the attack is
set to "DECAY" or "0."
RELEASE
This determines the time needed for the synthesizer sound to
reach zero from the moment the input of the guitar sound is
completed.
* When "BRASS" or "BOW" is selected for the wave, the guitar
signal itself is processed. That is, the synthesizer sound will go
down when the guitar signal goes down no matter how long the
release may be set.
VELOCITY
This adjusts the amount of the volume change of the
synthesizer sound. When it is set to high, the volume change
will be greater depending on the picking strength. When it is
set to "0," no volume change is caused even by changing the
picking manner.
HOLD
The hold function can sustain the output of the synthesizer
sound. If you turn on the hold while a synthesizer sound is
being output, the synthesizer sound will be held until you
turn it off.
You can control the on/off of the hold using the footswitch.
Normally, select "HOLD OFF."
* This parameter is used when "SQR" or "SAW" is selected for
the wave.
SYNTH LEVEL
This determines the volume of the synthesizer sound.
DIR LEVEL (direct level)
This determines the volume of the direct sound.
100
HOLD ON/OFF
To switch hold on/off using the foot switch (FS-5U, DP-2
(Roland), etc.), set "Control Assign" (p. 33) as follows.
< ASSIGN1: ON >
TARGET:
MOD (Guitar SYNTH): HOLD
TARGET MIN:
OFF
TARGET MAX:
ON
SOURCE TYPE:
CONTROL1
SOURCE MODE:
NORMAL
SOURCE MIN:
0
SOURCE MAX:
127
Advertisement
Table of Contents
