Table of Contents
Advertisement
Rear panel
fig.0-002
( 17 )
(10) AC Adapter jack
Connect the included AC adapter to this jack.
(11) MIDI IN/OUT
MIDI connectors (in/out)
An external MIDI device can be connected here to transmit/
receive MIDI messages to/from the VF-1. Use a MIDI cable
(sold separately) to make connections.
(12) EXP PEDAL/CTL 1,2
Expression pedal/Control 1,2 jack
Either an expression pedal or a foot switch can be connected
here, and used to step up/down through patch numbers, or
for realtime control of parameters. If a Roland PCS-31 (sold
separately) is used, you can use its two foot switches to
simultaneously control different parameters.
(13) DIGITAL OUTPUT
Digital output connector (coaxial)
A digital audio signal is output from this connector.
Use a video cable (75
unbalanced) to make connections.
(14) OUTPUT L (MONO) /R
Output jacks
These are the output jacks for the audio signal. Connect them
to your amp or mixer.
Use audio cables (separately sold) to make connections.
( 10 )
( 11 )
( 12 ) ( 13 )
( 14 )
(15) LEVEL
Level switch
Switch simultaneously regular input and output.
(16) INPUT L (MONO) /R
Input jacks
These are the audio input jacks. Connect them to a keyboard
or the like.
(17) Cord Hook
To prevent the AC adapter cord from being accidentally
disconnected, wrap the cord around this hook.
* If you wish to attach the rack mount adapter (RAD-50; sold
separately), refer to the manual of the rack mount adapter
(RAD-50).
* If you will be using the VF-1 by itself, without using the rack
mount adapter (RAD-50; sold separately), attach the included
rubber feet as shown in the diagram.
fig.0-03
Front and rear panels
( 15 )
( 16 )
13
Advertisement
Table of Contents
