Table of Contents
Advertisement
Section 2. Creating Sounds
Copying a patch
Here's how to copy the settings of the currently selected
patch into a different patch.
It is not possible to copy to a patch in a preset bank (PA1–
PA100, PB1–PB100).
* It is not possible to copy while you are editing.
fig.2-09
1. In Play mode, press [WRITE].
2. Rotate [NUMBER] to select the copy destination patch
number.
The number will change more rapidly if you hold down
[CATEGORY] as you rotate [NUMBER].
* It is not possible to select a patch number from a preset bank.
fig.2-10
3. Press [WRITE].
After the data has been written, "Complete !" will be shown
in the display, then you are returned to Play mode.
Never turn off the power while the display shows "KEEP
POWER ON !" If the power is turned off while this display is
shown, the VF-1 may malfunction or its data may be lost.
* If you press [EXIT] in step 2, the copy operation will be
cancelled and you will return to Play mode.
28
1,3
2
Turning an effect on/off
In the algorithm of the currently selected patch, you can turn
on the effect(s) that you wish to use, and turn off any unused
effect(s).
fig.2-11
1. In Play mode, press PARAMETER [
The following algorithm display screen will appear.
fig.2-12a
Off
2. Rotate the [VALUE] knob to select the effect that you
wish to turn on/off.
To move more rapidly between effects, hold down
[CATEGORY] as you rotate [VALUE].
3. Press [EFFECTS] to turn the effect on/off.
Depending on the algorithm, some effects cannot be
switched on/off. For details refer to "Algorithm list" (p.49–
p.90).
* You can also switch an effect on/off while making effect settings
(p.29).
If you wish to keep your modified settings, you must
perform the Write operation (p.38).
2,3
1
].
On
Advertisement
Table of Contents
