Table of Contents
Advertisement
The function of each parameter
Use the following procedure to create a user scale.
fig.4-305
1. Press [UTILITY].
2. Rotate [NUMBER] to select "SYSTEM."
fig.4-07
3. Press [ENTER].
4. Use PARAMETER [
5. Rotate the [NUMBER] knob to select the scale number
(SCALE#1–5) for which you wish to make user scale
settings.
fig.4-307
6. Use PARAMETER [
"INPUT" setting.
When you play a single note on your guitar, the VF-1 will
detect the note name and display it as the note name of the
input sound.
You can also rotate [VALUE] to specify the note name of the
input sound that you wish to change.
fig.4-308
7. Use PARAMETER [
"OUTPUT" setting.
102
1,9
2,3,5
4,6,7
][
] to select "USER#".
][
] to move the cursor to the
][
] to move the cursor to the
You can rotate [VALUE] to specify the note name of the
output note that corresponds to the input note.
fig.4-309
8. Repeat steps 6–7 to specify the output note for each input
note.
9. Press [UTILITY] to return to Play mode.
HUM CANCELER
(hum canceller)
This removes unwanted hum (electrical "buzz" or "drone").
EFFECT
This parameter turns the hum canceller effect on/off.
FREQUENCY
Hum will be removed at the specified frequency and at
multiples of that frequency. Set it to match the frequency of
your power supply.
WIDTH
Specify the width of the filter which will remove the hum.
DEPTH
Specify the depth of the filter which will remove the hum.
THRESHOLD
Adjust the level at which the hum canceller will begin to take
effect. If the signal falls below the specified level, only the
hum will be removed from the signal. With the maximum
setting, hum will always be removed regardless of the level
of the signal.
RANGE LOW
Specify the lower limit of the frequency range in which the
hum canceler will operate.
RANGE HIGH
Specify the upper limit of the frequency range in which the
hum canceller will operate.
Advertisement
Table of Contents
