Table of Contents
Advertisement
ENHANCER
By adding sounds which are out-of-phase with the direct
sound, this effect enhances the definition of the sound, and
pushes it to the forefront.
EFFECT
This parameter turns the enhancer effect on/off.
DETECT (detector in)
This is the parameters for both "STEREO MULTI" and "10
GRAPHIC EQ." Select the input source which will control
the enhancer.
L:
The input source of channel L will control the enhancer.
R:
The input source of channel R will control the enhancer.
LINK:
The input source whose level is higher will control the
enhancer.
SENS (sensitivity)
Adjusts the manner in which the enhancer will be applied
relative to the input signals.
FREQUENCY
Adjusts the frequency at which the enhancer effect will begin
to be applied. The effect will be made apparent in the
frequencies above the frequency set here.
MIX LEVEL
Adjusts the amount of phase-shifted sound of the range set
by "Frequency" that is to be mixed with the input.
LoMIX LEVEL (low mix level)
Adjusts the amount of phase-shifted sound of the lower
range that is to be mixed with the input.
LEVEL
Adjusts the volume of the enhanced sound.
The function of each parameter
FEEDBACKER
This allows you to use feedback playing techniques.
This effect can be used in the "GUITAR MULTI 2" algorithm
when the SFX "SELECT" parameter is set to "FB."
* For details on SFX settings, refer to "About SFX" (p.48).
When using the feedbacker, play a single note accurately and
then switch the effect on to produce a feedback effect. When
you turn the effect off, the feedback will disappear. Use the
foot switch to switch the effect on/off, so that the effect will
be on only while the pedal is being pressed. To make a note
feedback, you must cleanly play a single note. Then, when
the sound has stabilized, turn on the effect.
MODE
Select either oscillator "OSC" or boost "BOOST."
OSC (oscillator):
An artificial feedback sound will be created internally.
BOOST:
Only the frequency at which you want feedback will be
boosted, making it easier to use feedback playing techniques.
* Since boost mode only assists you with feedback playing, the
result will not be satisfactory if the volume of your guitar amp is
low.
RISE TIME
This determines the time needed for the volume of the
feedback sound to reach its maximum from the moment the
effect is turned on.
<When "OSC (oscillator)" is selected>
RISE TIME
This determines the time needed for the volume of the one
octave higher feedback sound to reach its maximum from the
moment the effect is turned on.
F.B LEVEL (feedback level)
Adjusts the volume of the feedback sound.
F.B
LEVEL (feedback level)
This adjusts the volume of the one octave higher feedback
sound.
VIB RATE (vibrato rate)
This adjusts the rate of the vibrato when the feedbacker is on.
97
Advertisement
Table of Contents
