Table of Contents
Advertisement
If you want an effect to become stronger
while you depress a foot switch, or for the
effect to be on only while the foot switch is
depressed
fig.2-71a
Momentary-type
Use a momentary-type foot switch, and select "NORMAL."
In this case, the setting (on/off) will depend on whether the
foot switch is depressed or not. This type of operation is not
possible with a latch-type foot switch.
Control Value Range
If a continuously variable controller such as an expression
pedal or pitch bend lever has been selected as the control
source, you can specify the range of values which will affect
the target parameter. The value of the target parameter will
not be affected by controller movements outside this
specified range, but will remain at the "Maximum" or
"Minimum" value.
When sets the SOURCE MIN: 40 and
SOURCE MAX: 80
fig.2-33
fig.2-35a
* The state in which the pedal is fully raised is "SOURCE=0,"
and the state in which the pedal is fully advanced is
"SOURCE=127."
The parameter value will change from TARGET MIN to
TARGET MAX as the pedal is operated (from SOURCE MIN
to SOURCE MAX). If the pedal is advanced further than
SOURCE MAX, or raised to less than SOURCE MIN, the
parameter value will be maintained at TARGET MAX or
TARGET MIN respectively.
0
40 (SOURCE MIN)
80 (SOURCE MAX)
127
Section 2. Creating Sounds
Controller: Expression Pedal
fig.2-35b
maximum value
TARGET MAX
minimum value
TARGET MIN
0
40
SOURCE
MIN
If effect on/off has been specified as the target, on/off will
occur at the central value between SOURCE MIN and
SOURCE MAX. If the pedal is advanced further than
SOURCE MAX or raised to less than SOURCE MIN, the
respective on or off setting will be maintained.
Controller: Expression Pedal
fig.2-35c
ON
OFF
OFF
0
40
SOURCE
MIN
* When you use an on/off-type controller such as a foot switch, set
the SOURCE MIN to "0" and the SOURCE MAX to "127." If
you set them to any other values, the parameter values may
remain unchanged.
* SOURCE MAX cannot be set to a value that is less than
Number Min.
For details on setting TARGET MIN and TARGET MAX,
refer to "Target value range" (p.33).
80
127
SOURCE
MAX
ON
60
80
127
Center
SOURCE
value
MAX
35
Advertisement
Table of Contents
