Table of Contents
Advertisement
CHOURUS
A sound with a subtly shifted pitch is added to the direct
sound, making the final output sound thicker and broader.
EFFECT
This parameter turns the chorus effect on/off.
POLARITY
This parameter is for the Stereo Chorus. It lets you choose the
difference in LFO phase for the left and right channels.
SYNC (synchro):
The left and right phase will be the same.
INVERT:
The left and right phase will be opposite.
MODE
Selection for the chorus mode.
MONO:
This chorus effect outputs the same sound from both L and
R.
ST. (stereo):
This is a stereo chorus effect that adds different chorus
sounds to L and R.
RATE
Adjusts the rate of the Chorus effect.
* If this is set to BPM, the MASTER BPM (p.105) setting for
each patch will determine the rate, so that the effect sound will
match the song tempo. However, if the BPM value is high, the
effect will synchronize to 1/2 or 1/4 of the BPM.
DEPTH
Adjusts the depth of the Chorus effect. To use it for doubling,
set the value to "0."
PRE DELAY
Adjusts the time needed for the effect sound to be output
after the direct sound has been output. By setting a longer
Pre Delay time, you can obtain an effect that sounds like
more than one sound is being played at the same time
(doubling effect).
LOW CUT (low cut filter)
The low cut filter cuts the frequencies below the specified
frequency. This setting adjusts the frequency at which the
low cut filter will begin to take effect. When "Flat" is
selected, the low cut filter will have no effect.
The function of each parameter
HIGH CUT (high cut filter)
This setting adjusts the frequency at which the high cut filter
will begin to take effect. When "Flat" is selected, the high cut
filter will have no effect.
FX (EFFECT) LEVEL
Adjusts the volume of the effect sound.
DIRECT SWITCH
Switch the direct sound ON/OFF (OUTPUT/NO OUTPUT).
COMPRESSOR/LIMITER
The compressor is an effect that attenuates loud input levels
and boosts soft input levels, thus evening out the volume to
create sustain without distortion.
The limiter attenuates loud input levels to prevent distortion.
EFFECT
This parameter turns the Compressor/Limiter effect on/off.
DETECT (detector in)
This parameter is for both "STEREO MULTI" and "10
GRAPHIC EQ." Select the input source which will control
the compressor/limiter.
L:
The input source of channel L will control the compressor/
limiter.
R:
The input source of channel R will control the compressor/
limiter.
LINK:
The input source whose level is higher will control the
compressor/limiter.
* If you edit an effect with "SELECT," the effect is parameter that
you have set before editing will be initialized.
SELECT
Select either Compressor or Limiter.
COMP (compressor):
The effect will function as a compressor.
LIMIT (limiter):
The effect will function as a limiter.
<When "COMP (compressor)" is selected>
EFFECT
This parameter turns the Compressor effect on/off.
93
Advertisement
Table of Contents
