Table of Contents
Advertisement
MONO:
The components of each frequency band will be located in
the center.
STEREO:
The odd-numbered frequency bands will be located at the
left, and the even-numbered components at the right.
L->R:
The low frequency bands will be located increasingly toward
the left, and the high frequency bands will be located
increasingly toward the right.
R->L:
The low frequency bands will be located increasingly toward
the right, and the high frequency bands will be located
increasingly toward the left.
HOLD
This turns the Hold function on/off. If you turn Hold on
while a voice is being input into the mic, the instrument will
sound with the vocal formats that are fixed at that time.
MIC SENS (mic sensitivity)
Adjust the input sensitivity of the mic.
SYNTH LEVEL (synthesizer in level)
Adjust the input level of the instrument.
CHAR [1]–[10] (voice character channel)
Adjust the volume of each frequency band. This setting
adjusts the tone of the vocoder. As the value is increased, the
frequency will rise.
MIC MIX
Adjust the amount of the mic audio (R channel input) which
has passed through the mic HPF that will be added to the
output of the vocoder.
MIC HPF
When mic mix is used, this adjusts the frequency at which
the high pass filter (HPF) will begin to affect the mic audio.
Higher values for this setting will allow you to mix only the
consonants. With a setting of Thru, the HPF will not be
applied.
MIC PAN L:R
Adjust the panning of the mic audio.
NS THRESHOLD
(noise suppressor threshold)
Adjust the level at which the noise suppressor applied to the
Mic input (R channel input) will begin to function.
The function of each parameter
HOLD ON/OFF
To switch hold on/off using the foot switch (FS-5U,DP-2
(Roland),etc.), set "Control Assign" (p. 33) as follows.
< ASSIGN1: ON >
TARGET:
VOCODER: HOLD
TARGET MIN:
OFF
TARGET MAX:
ON
SOURCE TYPE:
CONTROL1
SOURCE MODE:
NORMAL
SOURCE MIN:
0
SOURCE MAX:
127
VoiceTRANSFORM
(Voice Transformer)
This independently controls the basic pitch and the formants,
allowing a variety of voice characters to be created.
EFFECT
This parameter turns the voice transformer effect on/off.
ROBOT
Turn the robot function on/off. When this is on, the audio
will be output at a fixed pitch regardless of the pitch that is
input, producing a voice character without inflection.
CRMTC PITCH (chromatic pitch)
Adjust the pitch of the voice character in semitone steps. This
can be adjusted over a range of 1 octave down to 1 octaves up.
FINE PITCH
Make fine adjustments to the pitch of the voice character.
CRMTC FRMT (chromatic formant)
Adjust the formant of the voice character in semitone steps.
This can be adjusted over a range of 1 octave down to 1
octaves up.
FINE FRMT (fine formant)
Make fine adjustments to the formant of the voice character.
MIX BAL (mix balance)
Adjust the balance between the voice character volume and
the normal voice volume. When the value is set to "0," only
the normal voice will be output, while only the voice
character sound is output when it is set to "100."
119
Advertisement
Table of Contents
