Building A Part From Your File - µ-Dimension SST 1200es User Manual

38 Operation

Building a Part From Your File

1. If a part has not been sent to the printer for build (the build
queue is empty):
For detailed information about the CatalystEX Build Queue, refer
"Sending Your CAD File to the System" on page 39
to
CatalystEX Help files.
a. The panel displays Idle and Queue Empty.
b. Wait for Part is blinking. Choose whether you want to
start the build process from a 'remote' location or from the
display panel at the printer.
(1) At Printer 'Start Model' - You send a part to the printer
from your CatalystEX work station. You start the build
of the part from the printer.
(a) Do not press the Wait for Part button.
(b) From your CatalystEX work station, send a part to
(c) The printer panel displays the name of the first
(d) From the printer, press the Start Model button
(2). Remote 'Start Model': - You send a part to the printer
from your CatalystEX work station. The part
automatically begins to build.
(a) From the printer, press the Wait for Part but-
(b) Make sure an empty modeling base is installed,
(c) Wait for Part is displayed in the upper
(d) From your CatalystEX work station, send a part to
Dimension BST 1200es / SST 1200es User Guide
NOTE
the printer.
model in the printer queue and Start Model is
blinking.
to begin building the displayed part.
ton.
then answer Yes to the prompt Is Model Base
Installed?
window. Press Cancel if you wish to exit the
remote start mode.
the printer. The printer will automatically start to
build the model.
and the