Replacing The Brush/Flicker Assembly - µ-Dimension SST 1200es User Manual

Replacing the Brush/Flicker Assembly

(Refer to Figure 16 on page
The brush/flicker should be replaced after 500 hours. Prior to
Performing Tip Cleaning Assembly Maintenance
1. Completely power down Dimension. See on
Dimension" on page 31.
2. Move the Toggle Head to the left of the machine in order to
gain access to the Brush/Flicker Assembly
Move Toggle Head
to the left
Figure 15: Move the Toggle Head to the left
3. Remove the Brush/Flicker Assembly by lifting the assembly up
and out of the machine. Discard the old Brush/Flicker
Assembly (Figure
Figure 16: Replacing the Brush/Flicker Assembly
4. Place the new Brush/Flicker Assembly over the two mounting
posts making sure the assembly is fully seated.
47).
NOTE
16).
Dimension BST 1200es / SST 1200es User Guide
Maintenance 47
"Powering Off
(Figure 15).
Brush/Flicker
Assembly