Table of Contents
Advertisement
Troubleshooting Checklist
Problem or error message
No power
System fails to reach operating
temperatures
Material not extruding
Purge material accumulating on
part.
No text displayed on Display
Panel
Cannot communicate with system
through network
Troubleshooting
Solution
Verify power cord is securely plugged in.
Verify that the circuit breaker (at rear of system)
and the power switch (on front panel of system)
are both in the ON position.
Verify AC power is present at wall outlet.
Verify the system is not connected to an
extension cord or power strip.
Filament may be jammed in extrusion head (see
"Loss of Extrusion" on page 63.
Material may have accumulated behind tips. (See
See "Tip Area Clean-up" on
page 58.
Make sure that the flicker and brush are set to the
proper height. (
Flicker Assembly" on page 47.
Check condition of Flicker and Brush. Replace if
"Replacing the Brush/Flicker
worn. (
Assembly" on page 47.
Cycle power (see
page 31.
Make sure network cables are connected - at the
printer, at the PC, and where cables connect to
network boxes.
Dimension BST 1200es / SST 1200es User Guide
"Replacing the Brush/
)
"Cycling Power" on
).
).
)
Hide quick links:
Advertisement
Table of Contents
