Table of Contents
Advertisement
36 Operation
Unloading Material
The model and support material cartridges may be replaced
separately or at the same time. In idle-, load-, or build-related
modes, the panel displays the percentage of material remaining in
the cartridges. If the printer will be operating unattended for a long
period, and the material level is getting low, you may want to
replace the cartridges before starting a new part. Of course, you
will also need to replace the cartridges when they are empty.
Unload material cartridges:
1. From Idle (or Ready To Build), Press Load Material.
A. The panel displays Load Material and prompts with,
Replace model?
•
Press Yes. to unload the Model Material.
The panel displays Replacing model,
•
Press No if you do not wish to unload the model
material.
B. The panel then prompts with, Replace support?
•
Press Yes. to unload the Support Material.
The panel displays Replacing support,
•
Press No if you do not wish to unload the support
material.
C. After you have made the above choices, the panel displays
Unloading for approximately 2 minutes (the selected
materials will be unloaded from the extrusion head).
D. When unloading is complete, the panel will prompt you to
remove a cartridge based upon your choices - i.e.,
Replace Both Cartridges, Replace Model
(Top) Cartridge, or Replace Support (Bottom)
Cartridge.
Dimension BST 1200es / SST 1200es User Guide
Hide quick links:
Advertisement
Table of Contents
