Inserting A Modeling Base; Powering On Dimension - µ-Dimension SST 1200es User Manual

30 Operation

Inserting a Modeling Base

Prior to inserting a modeling base into the tray, remove any
material buildup on and behind the Z Platform and around the lead
screw. Failure to do so could cause the modeling base to be
unlevel or, if the amount of buildup is large enough, the Z Platform
could jam at its upper limit.
Install the modeling base
- "Setup").
Reusing a modeling base:
The base is intended for single-use only on each modeling area.
A modeling base may become worn or distorted after a build. The
printer performs a modeling base levelness check at the start of
every part build; upon detection of a faulty modeling base, the
printer pauses and allows you to install a new one.

Powering On Dimension

Refer to "Powering On Dimension" on page 20
Dimension BST 1200es / SST 1200es User Guide
(See "Insert Modeling Base" on page 21.
Building on a used modeling area may
cause loss of extrusion or cause a part to
curl or break loose from the modeling
base.
Failure to completely remove all other
layers from a previous build can cause a
head collision and result in system
damage.
CAUTION
CAUTION
for instructions.