Removing A Completed Part - µ-Dimension SST 1200es User Manual

.

Removing a Completed Part

When the part has completed, the panel displays Completed Build,
and the file's name. It also shows Remove Part and Replace
Modeling Base.
Remove a completed part from the Dimension system:
1. Open the modeling chamber door.
2. Release the modeling base retainers and pull the modeling
base towards you, out of the tray guides.
3. Insert a new modeling base.
4. Close the modeling chamber door.
5. After you have opened and closed the door, the panel displays
Part Removed? only after removing the part, press Yes.
• After you press Yes, the panel displays the status as
Ready to Build for the next part in the queue.
Remove a completed part from the modeling base:
1. After removing the base from the printer, firmly flex the
modeling base back and forth with your hands to loosen the
part. From best results, flex the modeling base front-right to
back-left.
If you press Yes before removing the
part, the system can be damaged and a
service call will be required
The system can be damaged if your
answer Yes and the part has not been
removed!
Dimension BST 1200es / SST 1200es User Guide
CAUTION
.
CAUTION
Operation 43