Connecting Directly To Your Pc - µ-Dimension SST 1200es User Manual

26 Setup
C. In the pop-up, 'Add 3D Printer', enter a Name and Location
(your choice) for your printer in the appropriate fields.
D. Enter the IP Address for your printer in the appropriate
field. It will be the same address as the one entered in Step
5.
E. Select the appropriate printer type from the drop down list.
F. Click 'Add Printer' and close the 3D Printer pop-up.
14. If you are unable to connect the printer to your PC, contact
your Network Administrator.

Connecting Directly To Your PC

You can connect the Dimension printer directly to your PC without
the use of a network. This is most easily accomplished with the
printer in Dynamic network mode (as received from the factory).
1. Connect a crossover cable from your printer directly into a
network port on your PC (A 14 foot crossover cable (orange) is
included with the Start Up Kit.)
2. The UDN for your printer is listed here. This is preset at the
factory preset and cannot be changed.
A. From Idle (or Ready to Build) press Maintenance. The
panel displays Maintenance and the software version.
B. Press System.
C. Press Set Network. The top window displays: Network -
Dynamic IP Address; UDN
D. The UDN for your printer is listed here. This is factory
preset cannot be changed.
3. From your PC, start the CatalystEX application.
Detailed instructions for using CatalystEX can be found in the
CatalystEX Help file.
A. From the General Tab, click the 'Manage 3D Printers'
button.
Dimension BST 1200es / SST 1200es User Guide
NOTE