Watts Aerco Benchmark OMM-0117 Operation And Maintenance Manual page 145

Benchmark 5000-6000 Operation & Maintenance Manual
APPENDIX J – LONG TERM STORAGE
Appendix J: LONG TERM BLOWER STORAGE
CAUTION!
Failure to adhere to the instructions below voids all warranties in their entirety.
Damage can result if the Blower is left in long term storage (exceeding 30 days after receipt of
equipment). If the Blower is kept in storage for more than 30 days, you must you must complete
the instructions below.
Long Term Blower Storage Instructions
1. Select a suitable storage site:
•
Level, well-drained, firm surface, in clean, dry and warm location. Minimum temperature
of 50°F (10°C).
•
Isolated from possibility of physical damage from construction vehicles, erection
equipment, etc.
•
Accessible for periodical inspection and maintenance.
The blower should be supported under each corner of its base to allow it to "breath". Supports
2.
(2 x 4's, timbers, or railroad ties) should be placed diagonally under each corner.
If the equipment is to be stored for more than three (3) months, the entire blower assembly
3.
must be loosely covered with plastic, but not tightly wrapped.
Storage Maintenance:
4.
NOTE:
A periodic inspection and maintenance log, by date and action taken, must be developed and
maintained for each blower. See example below. Each item must be checked monthly.
Example Storage / Maintenance Schedule Log
Item
1 Re-inspect units to insure any protective devices used
are functioning properly. Check for scratches in the
finish which will allow corrosion or rust to form
2 Rotate wheel a minimum of 10 full revolutions to keep
the motor bearing grease from separating and drying
out.
OMM-0118_B • GF-203 • 5/9/2019
Action
(THIS STEP IS CRITICAL!)
(Continued)
Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST
Dates Checked
Page 145 of 148