6-13. Associating Arcreach; Devices (Arcreach Models Only) - Miller Trailblazer 325 Diesel Owner's Manual

�
Complete Parts List is available at www.MillerWelds.com

6-13. Associating ArcReach

Devices (ArcReach Models Only)

®
Stop engine.
NOTICE – Do not exceed machine duty cycle.
Associating ArcReach Device To Engine Driven Welder/Generator
Make connections between welder/generator and ArcReach device. See Owner's Manual for ArcReach device for typical connection
diagrams.
The welder/generator has the ability to associate automatically with an ArcReach device at power up. The Process/Contactor switch must be
set to an Output ON mode to associate with an ArcReach device.
See the ArcReach device Owner's Manual to associate the device to the welder/generator.
When the association process is complete, the In Use light will be illuminated. Depending on the capabilities of the ArcReach device, the Proc-
ess/Contactor switch, Adjust Control/Select button, and Arc Control adjustment may be overridden.
The following ArcReach accessories are compatible with this welder/generator:
ArcReach Stick/TIG Remote ArcReach SuitCase Feeders
For Stick Or TIG Welding For MIG Or FCAW Welding
2744
When welder/generator is associated with SuitCase ArcReach
When welder/generator is associated with Stick/TIG Remote:
feeder, voltage and wire feed settings are adjusted on the feeder.
274460-A / 266206-D
SMAW processes: Amperage, Electrode Type, and Arc Control set-
tings are adjusted on the remote.
GTAW and CAC-A processes: Amperage settings are adjusted on the
remote.
ArcReach Smart Feeder ArcReach Heater
For Advanced Wire Processes
274460-A / 266206-D
When welder/generator is associated with Smart Feeder, all controls When welder/generator is associated with ArcReach Heater, use the
switch to the feeder, and the display reads SMRT ACC. wire negative (–) output stud on the welder/generator.
�
When using an ArcReach device, engine speed is always weld/
power speed.
OM-279836 Page 39