Associating Arcreach Devices (Arcreach Models Only) - Miller Big Blue 600 Air Pak Owner's Manual

6-13. Associating ArcReach Devices (ArcReach Models Only)

! Stop engine.
NOTICE − Do not exceed machine duty cycle.
Associating ArcReach Device To Engine Driven Welder/Generator
Make connections between welder/generator and ArcReach device. See Owner's Manual for ArcReach device for typical connection
diagrams.
The welder/generator has the ability to associate automatically with an ArcReach device at power up. The Process/Contactor switch must
be set to an Output ON mode to associate with an ArcReach device.
See the ArcReach device Owner's Manual to associate the device to the welder/generator.
When the association process is complete, the In Use light will be illuminated. Depending on the capabilities of the ArcReach device, the
Process/Contactor switch, Adjust Control/Select button, and Arc Control adjustment may be overridden.
The following ArcReach accessories are compatible with this welder/generator:
ArcReach Stick/TIG Remote
For Stick Or TIG Welding
When welder/generator is associated
with Stick/TIG Remote:
SMAW processes: Amperage,
Electrode Type, and Arc Control
settings are adjusted on the remote.
GTAW and CAC-A processes:
Amperage settings are adjusted on the
remote.
.
Complete Parts List available at www.MillerWelds.com
ArcReach SuitCase Feeders
For MIG Or FCAW Welding
When welder/generator is associated
with Suitcase X-TREME ArcReach
feeder, voltage and wire feed settings
are adjusted on the feeder.
ArcReach Smart Feeder
For Advanced Wire Processes
When welder/generator is associated
with Smart Feeder, all controls switch
to the feeder, and the display reads
SMRT FEDR.
.
When using an ArcReach device,
engine speed is always
weld/power speed.
274460-A / 266206-D
OM-279640 Page 51