Mode Switch Settings; Associating Arcreach Device To Arcreach Power Source - Miller XMT 450 CV Owner's Manual

6-2.

Mode Switch Settings

Switch Position
WIRE - Gas
MAW
WIRE - Gas*
WIRE - No Gas*
STICK EXX18*
STICK EXX10*
GOUGE*
Lift-Arc TIG*
TIG
*An ArcReach device will override any control connected to remote 14-pin receptacle.
**See Section 9-4 Alternate Configuration Functions
6-3.

Associating ArcReach Device To ArcReach Power Source

Quick Setup Guide:
1 Make connections between power source and ArcReach device. (See section pertaining to mode being used for typical connection
diagrams).
2 This power source has the ability to associate with an ArcReach device at power up, or when an ArcReach wire feeder is triggered. The
Mode Switch on this power source must be set to an "OUTPUT ON" mode to associate with another ArcReach device.
3 See instructions in the owner's manual for the specific ArcReach device to associate the device to this power source.
4 During the association process the Remote in Use indicator will blink.
5 When the association process is complete, the Remote In Use indicator will be lit. Dependent on the capabilities of the ArcReach device;
the mode switch, voltage/amperage adjustment, and Arc Control adjustment may be overridden by the ArcReach device.
Process Output Control
GMAW
Remote 14
FCAW
GMAW
Electrode Hot
FCAW
FCAW-S Electrode Hot
SMAW Electrode Hot
SMAW Electrode Hot
CAC-A Electrode Hot
GTAW Electrode Hot
GTAW Remote 14
Panel Adjust Remote 14
Adjust
Volts Volts
Volts Volts
Volts Volts
Amps % Panel Amps**
Amps % Panel Amps**
Amps % Panel Amps**
Amps % Panel Amps
Amps % Panel Amps
ArcReach
Adjust
- -
Volts
Volts
Amps
Amps
Amps
Amps
- -
OM-292663 Page 25