Making Dual Operator Cv Weld Connections W/ Separate Work Cables - Miller Big Blue 700 Duo Pro DLX SF Owner's Manual

5-9. Making Dual Operator CV Weld Connections w/ Separate Work Cables

A. 700 And 700X Duo Pro Models
Welder A (Left) Side
1
!
Stop engine.
NOTICE − Do not exceed machine duty
cycle.
.
Use Dual Operator mode for CC and
CV welding (see Section 6-2).
See Section 5-14 for proper cable size.
.
Complete Parts List available at www.MillerWelds.com
.
Optional Weld Selector switch shown.
Direct Current Electrode Positive
(DCEP) connections are shown.
2
1 Wire Feeder Cables
2 Work Cables
For MIG and FCAW welding Direct Current
Electrode Positive (DCEP), connect work
cables to Negative (−) terminals and wire
feeder cables to Positive (+) terminals.
Tools Needed:
Welder B (Right) Side
1
Ref. 251 340-A / Ref. 802 292-A
For MIG and FCAW Direct Current Elec-
trode Negative (DCEN), connect work
cables to Positive (+) terminals and wire
feeder cables to Negative (−) terminals.
.
Be sure Process Selector switches are
set correctly. See Section 6-3.
3/4 in.
2
OM-252624 Page 33