Making Dual Operator Cc Weld Connections W/ Separate Work Cables (800 Models) - Miller Big Blue 600 Air Pak Owner's Manual

5-8. Making Dual Operator CC Weld Connections w/ Separate Work Cables (800 Models)

.
Welder A (Left) Side
1
! Stop engine.
NOTICE − Do not exceed machine duty
cycle.
.
Use Dual Operator mode for CC and
CV welding (see Section 6-2).
See Section 5-15 for proper cable size.
OM-279640 Page 30
.
Complete Parts List available at www.MillerWelds.com
Direct Current Electrode Positive
(DCEP) connections are shown.
Welder B (Right) Side
2
1 Electrode Holder Cables
2 Work Cables
For Stick/TIG welding Direct Current Elec-
trode Positive (DCEP), connect work
cables to Negative (−) terminals and elec-
trode holder cables to Positive (+) ter-
minals.
1
For Stick/TIG Direct Current Electrode
Negative (DCEN), connect work cables to
Positive (+) terminals and electrode holder
cables to Negative (−) terminals.
.
Be sure Process Selector switches
are set correctly. See Section 6-4.
Tools Needed:
3/4 in.
258 836