Table of Contents
Advertisement
User Manual
Ouster LiDAR
Configure One LiDAR
©
Danfoss | March 2023
Configure Ethernet Output Using External DHCP Service
Follow these steps to configure the Ethernet output to communicate with an external DHCP service.
When configured, the DHCP service assigns the controller an IP address.
1. From the top of the application, enter the Outputs page, then the Ethernet page. Do not open the
USBEthernet page.
2. Set Enable to True.
3. Set DHCP to 7.
4. Set DHCPService_Enable to False.
You do not need to modify any of the other settings. The controller receives an IP address from the
external DHCP service.
5. Compile the application.
AQ404281942428en-000103 | 25
Advertisement
Table of Contents
