Table of Contents
Advertisement
User Manual
Ouster LiDAR
Configure One LiDAR
©
Danfoss | March 2023
The following image shows the Ethernet output page after deleting the wire bus segment.
3. Compile the application.
Configure Using the Controller DHCP Service
Follow these guidelines when configuring the Ouster LiDAR hardware with a controller using the DHCP
service on the controller.
•
Mount and connect the Ouster LiDAR hardware following guidelines in the hardware user manual
provided by Ouster.
•
Use an M12 to RJ45 Ethernet cable to connect the controller to the management port on a network
smart switch.
•
Connect the Ouster LiDAR hardware to the network smart switch.
AQ404281942428en-000103 | 21
Advertisement
Table of Contents
Need help?
Do you have a question about the PLUS+1 Compliant and is the answer not in the manual?
Questions and answers