Nat Mappings - peplink Pepwave MAX 700 User Manual

17

NAT Mappings

NAT mappings allow IP address mapping of all inbound and outbound NAT'd traffic to and from
an internal client IP address. Settings to configure NAT mappings are located at Advanced >
NAT Mappings.
To add a rule for NAT mappings, click Add NAT Rule.
LAN
Client(s)
Address
Range
Network
Inbound
https://www.peplink.com
NAT Mapping Settings
NAT mapping rules can be defined for a single LAN IP Address, an IP Range, or
an IP Network.
This refers to the LAN host's private IP address. The system maps this address
to a number of public IP addresses (specified below) in order to facilitate inbound
and outbound traffic. This option is only available when IP Address is selected.
The IP range is a contiguous group of private IP addresses used by the LAN host.
The system maps these addresses to a number of public IP addresses (specified
below) to facilitate outbound traffic. This option is only available when IP Range
is selected.
The IP network refers to all private IP addresses and ranges managed by the LAN
host. The system maps these addresses to a number of public IP addresses
(specified below) to facilitate outbound traffic. This option is only available when
IP Network is selected.
This setting specifies the WAN connections and corresponding WAN-specific
173 Copyright @ 2021 Pepwave