Upnp / Nat-Pmp Settings - peplink Pepwave MAX 700 User Manual

The Port setting specifies the port(s) that correspond to the service, and can be
configured to behave in one of the following manners:
Any Port, Single Port, Port Range, Port Map, and Range Mapping
Any Port: all traffic that is received by the Pepwave router via the specified protocol is
forwarded to the servers specified by the Servers setting. For example, with IP
Protocol set to TCP, and Port set to Any Port, all TCP traffic is forwarded to the
configured servers.
Single Port: traffic that is received by the Pepwave router via the specified protocol at
the specified port is forwarded via the same port to the servers specified by the Servers
setting. For example, with IP Protocol set to TCP, and Port set to Single Port and
Service Port 80, TCP traffic received on port 80 is forwarded to the configured servers
via port 80.
Port Range: traffic that is received by the Pepwave router via the specified protocol at
the specified port range is forwarded via the same respective ports to the LAN hosts
Port
specified by the Servers setting. For example, with IP Protocol set to TCP, and Port
set to Port Range and Service Ports 80-88, TCP traffic received on ports 80 through
88 is forwarded to the configured servers via the respective ports.
Port Mapping: traffic that is received by Pepwave router via the specified protocol at
the specified port is forwarded via a different port to the servers specified by the Servers
setting.
For example, with IP Protocol set to TCP, and Port set to Port Mapping, Service Port
80, and Map to Port 88, TCP traffic on port 80 is forwarded to the configured servers
via port 88.
(Please see below for details on the Servers setting.)
Range Mapping: traffic that is received by the Pepwave router via the specified protocol
at the specified port range is forwarded via a different port to the servers specified by
the Servers setting.
Inbound IP
This setting specifies the WAN connections and Internet IP address(es) from which the
Address(es) service can be accessed.
Server IP
This setting specifies the LAN IP address of the server that handles the requests for the
Address
service.

16.1 UPnP / NAT-PMP Settings

UPnP and NAT-PMP are network protocols which allow a computer connected to the LAN port
to automatically configure the router to allow parties on the WAN port to connect to itself. That
https://www.peplink.com 171 Copyright @ 2021 Pepwave