Setting The Angle; Control Modes; One Performer (Static Mode); One Performer (Built-In Programs) - SHOWTEC Performer Profile 600 Q4 Manual

Performer Profile 600 Q4

Setting the angle

01) Loosen the adjustment screws (do not remove them).
02) Tilt the fixture to the desired position (Fig. 11).
03) Tighten the adjustment screws to secure the fixture in position.

Control Modes

There are 4 modes:

One Performer (Static Mode)

01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) When the Performer is not connected with a DMX cable, it functions as a stand-alone device.
Please see page 22 for more information about the Static Mode.

One Performer (Built-in Programs)

01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) When the Performer is not connected with a DMX cable, it functions as a stand-alone device.
Please see page 23 for more information about the Built-in Programs.
Ordercode: 33061
• Static mode
• Built-in programs
• Master/Slave
• DMX-512 (3CH, 3CH, 4CH, 4CH, 5CH, 6CH, 10CH, 15CH)
15
Fig. 11