Table of Contents
Advertisement
Performer Profile 600 Q4
Installation
Remove all packing materials from the Performer Profile 600 Q4. Check if all foam and plastic padding is
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply.
Lens Locations
The different lenses used in the Performer are not interchangeable. When installing a new lens, refer to
the illustration below for proper placement.
Fig. 04
Focusing the beam
01) Loosen the beam focus controls located under the barrel (Fig. 05).
02) Slide the lens tube forwards or backwards to achieve the desired beam edge.
03) Once the fixture is focused, tighten the beam focus controls.
Fig. 05
Ordercode: 33061
11
Advertisement
Table of Contents
