Figure 11 Removing the
Restraining Bolt
Note:
If this is a multiple stack configuration, see
36 for information on preparing the library chassis for passing tape
cartridges from one unit to another.
2 Remove the restraining bolt from the left-hand side of the library (see
3 Install the library into the rack as shown in
with four Phillips screws.
Warning:
The Scalar 50 tape library weighs approximately 52 lbs (23.6 kg). At
least two people are required to lift and install the library.
Installing the Library
Scalar 50 Tape Library
Multiple Library Stacks
figure 12
and secure the library to the rack
on page
figure
11).
17